Changes

Jump to navigation Jump to search

Digging

6,872 bytes added, 17 January
m
Digging requires a [[ShovelCDB|Main]]. Activate shovel ---> Right-click a tile (any but rock) and select Dig. This will lower the ground and put 1x of the tile compound in your inventory. The ground is lowered at the closest corner to where you are standing, rather than where you click./ [[Skills]] / '''{{PAGENAME}}'''
So if you want ==Description==Digging is the [[skill]] of terraforming or moving [[dirt]] around. It is used either to raise or lower a [[tile stand in ]] or the corner sides of the a tile activate your shovel, right click>Dig this will lower to change the appearance of the corner world around you are standing on. To lower the whole tileDigging requires a [[shovel]] and increases several [[characteristics]]: [[body strength]], [[body stamina]], you must stand in each of the four coners in turn and dig[[mind logic]]. This is the same for raising [[Destroy pavement|Destroying pavement]] and cultivating a [[packed dirt]] tile, just drop dirt instead of digalso increases the digging skill.
When You think you have ==Method==*Activate a tile nearly flat you can find out if it is perfectly flat by right clicking>flatten.. If the timer that tells you how long left there is to perform the task starts at 0:09 seconds then it is flat. If it doesn't start at this time shovel and right -click again a tile and select stop"Dig". Then dig where u need to flatten This will lower the [[ground]] and drop the dug material in a collectible pile on that tileor nearby.
A better way to check *'''Note that the material is dug from the flatness corners of an edge tiles; Where your avatar's feet are (which of the four corners in the tile you stand in) is where the tile will be dug down. Where you right-click to press select the dig command has absolutely no impact whatsoever on where you dig.'c' key' So, for example, by standing in the northwestern corner of a tile and digging, then look at one just that area of the tile and if connecting tiles will drop. The other three corners of the tile will remain at their original level. By then hovering the line is straightcursor over neighboring tile borders, one can then you are sure it see the results of their work via slope count (1 slope = 1 dirt = 1 dig action). Dropping dirt on tile corners works the same way but by raising the corner in which the player is flatstanding when dropping the dirt.
==Digging for rock:==*The maximum slope you can dig on, level, or flatten is 3 x [your digging skill] + 1. e.g. A skill of 50.25 in digging will mean you can dig on, or adjacent to, a slope of up to 151 dirt.*For skills below 10, you can dig slopes up to 30.
If you want *It is not possible to dig for a rock tile you must be aware that you could dig alot of dirt. To start you must dig a reasonabe distance above water, keep digging in one corner till you "hit rock" on [[cliff]] or you dont have enough skill to dig deeper. Once you hit [[rock in one corner you must then dig till you hit rock in the other corners of the tile]]s. Doing so you will un-cover the rockRock tiles can be [[Mining#Surface_mining|mined]] down.
*To lower a whole [[Categorydirt tile|dirt]], [[moss tile|moss]], [[tundra]], [[steppe tile|steppe]], or [[sand tile]], you must stand in each of the four corners and dig. To raise a tile, you must drop dirt on the tile corners. Clay tiles will lower every 50-100 actions while digging corners. When on tiles like [[peat]] or [[tar]], digging produces material each dig, but will not lower the corner. You must use [[level]]ing for these tiles.  *To check if a tile is flat, you can either right-click a tile and select '''[[flattening|Flatten]]''' or examine the tile's borders. If all tile borders say "The [[slope]] is level", then tile is flat. You can also see the difference in height between tile sides by examining the tile's borders. The reference will be a certain number of units of material either away from you or toward you relative to where you are standing. For example, if the slope is 2 dirt steep ''towards'' you, go to the other end of the tile border you examined and dig twice to level the edge in question. To avoid confusion in the beginning when examining tile borders, stand near, or preferably on, the blank non-highlightable "mini-square" at the corner of a tile. ==Notes==* You need 10 digging and 20 body strength to destroy pavement.* You need 20 body strength to dig on roads.* Trees will obstruct digging is when there is a tree in the NE, NW, and SW tiles. Cut down that tree and you can continue digging. * Digging holds a chance to reward you with [[strange bone]]s & [[emerald]]s. Anybody, even non premium accounts have the chance of finding emeralds. Only premium accounts have the chance of finding rare bones.* Having a shovel activated will give a mouse tool indicating the [[slope]] of a tile border when you mouse over it.* Digging can be done while moving, so long as you do not move too far (two tiles) from the tile you are currently digging. ==PVP Servers==* Maximum slope on dirt is limited to 150 on the [[Defiance]] and [[Elevation]] servers, no matter how high the skill a player may have.  == Warning Messages ==; The concrete would only flow away.: Occurs when trying to raise a rock tile that is greater than 40 slope. It only takes into consideration the 4 adjacent slope borders.; The frozen soil is too hard to dig effectively.: Occurs when there is tundra next to it; The <item> would flow down into a <structure/fence>. You are not allowed to drop <item> on <structures/fences>: Occurs when trying to drop a dirt that is adjacent to a structure/fence in which the slope is more than 40.; The <structure/fence> is in the way.: Occurs when trying to dig in a corner where there is a <structure/fence> present.; The object nearby prevents digging further down.: An object, such as a [[bulk storage bin]] may prevent digging steep slopes.; The road would be too steep to traverse.: You cannot dig a highway road to over 20 slope steep.; The water is too deep to cultivate here.: Occurs when trying to cultivate a tile in which the northwest corner is not 0 dirts or more above the water table.; The water is too deep or too shallow to dig using that tool: You can only dig 7 dirt below water level with a shovel before you have to switch to a [[dredge]].; The water is too deep and would only dissolve the concrete.: When using [[concrete]] to raise a tile below water the lowest height that the tile can be is 25.; The water is too deep to pack the dirt here.:Occurs when trying to pack a tile in which the northwest corner is more than 0 dirts below the water table.; The water is too deep to pave here.: Occurs when trying to pave a tile in which the northwest corner is more than 0 dirts below the water table.; You are not allowed to drop dirt there.: Cannot drop dirt on paved road when the corner is surrounded on all sides by trees or similar tiles.; You are not skilled enough to dig in such steep slopes.: Slopes become too steep when the dirt slope is greater than 3x your digging skill. This includes any slopes on any tiles bordering the tile you wish to dig on. For example, with 15 digging skill, you can dig on, level, or flatten a slope up to 45 steep.; You can't flatten at that depth.: Occurs when trying to flatten a tile in which is the involved tiles are 7 or more dirts below the water table.; You can't level at that depth.: Occurs when trying to level a tile in which the involved tiles are 7 or more dirts below the water table.; The area is too crowded with (trees / bushes / trees and bushes) to dig properly.: This message happens when the corner is surrounded by 3 or 4 tree or bush tiles. Cut down one (or more) to continue.; You cannot dig in such terrain.: This message will occur when trying to lower floorboards through a dig action.; You hit rock.: All the dirt above the rock layer in this tile corner has been dug away.; You suddenly become very weak, and your arm muscles fail you. You just can not dig here it seems.: You are trying to dig within a planned house.; You can't figure out how to remove the stone. You must become a bit better at digging first.: You need 10 digging to remove pavement.; You need to be stronger to destroy pavement.: Body strength of 20 and a digging skill of 10 is required for destroying pavement.; You need to be stronger to dig on roads.: You need 20 body strength to dig on roads.; Your shovel fails to penetrate the earth no matter what you try. Weird.: You are trying to dig in an area protected by the GMs. Find a different spot. ==Burying== Activate a shovel, right-click the corpse and select '''Bury'''. *Note: a [[crude shovel]] does <u>not</u> provide the bury action. Burying is generally designed for the disposal of a corpse. An unbutchered corpse will attract carnivores so therefore it is a respectful act to bury an animal after you kill it. It is a good idea to [[butchering|butcher]] the animal with a [[butchering knife]] before it is buried. Also, remember to bury your own corpse after you pick up its inventory. If you try to bury something on a rock tile, cave tile, or a dirt tile where the dirt is less than 3 dirts deep you will fail and get the message, "The ground is too hard to bury anything in using a shovel, try using a pickaxe." However, it is possible to bury corpses on a rock tile and or a cave tile with a [[pickaxe]]. ==Under water==Until 7 dirt below sea level, you can dig as above water, but deeper than 7 you must [[dredge]] instead of dig. ==Digging for Rock Guide==To set up a mine where there is no exposed rock, you must first reveal the rock layer under the dirt layer. Dig at a reasonable distance above [[water]]. Keep digging in one corner until "You hit rock" or do not have enough skill to continue digging. Once you hit rock in one corner, then you must dig in all other corners until they have hit rock also. When you hit rock in all four corners, then the rock tile will be uncovered. If you lack the skill to dig in "such steep slopes", you could dig the nearby tiles down further as well, to reduce the slope to the corners you are working on. ==Tile Difficulties==Digging difficulty varies by tile. The formula starts at 1 + (the highest slope from that corner/5, rounded down), then adds the specific tile difficulty.  * Dirt - 0* Peat - 0* Sand - 10* Moss - 10* Clay - 20* Tundra - 20* Marsh - 30* Tar - 35* Steppe - 40 ==Skills& Characteristics==* [[Digging]]* [[Body]] > [[Body strength]]* [[Mind]] > [[Mind logic]]* [[Body]] > [[Body stamina]] (On PVE servers only)* [[Soul]] > [[Soul strength]] (On [[Epic]] servers only) ==[[Titles]]==* Digger at 50 skill* Excavator at 70 skill* Land Shaper at 90 skill* Earthwurm at 100 skill
==Flatening Guide:See also==To make a patch of ground perfectley flat is an art, and requires patience. Below is a guide on how to flatten one tile.* [[Tile types]]<br><br>* [[Guides/Flattening|Flattening]]When flatening you should not use the "flatten" option, this is only used to check if the tile is flat.* [[Leveling]]<br><br>* [[Guides/FlatRaising|Flatraising]]If when flatening a tile it takes 9 seconds, then the tile is completley flat, if it is anything else then you should stop the action straight away so you dont ruin tiles around the one you are trying to flatten.* [[Guides/Landbridges|Landbridges]]<br><br>You should always dig down the tile until it looks flat, you need to check the tile from all angles (North, East, South, West) this will ensure that you have no slopes on the tile. You can check for slopes by looking at the tile outline, the outline should be completley flat when you are looking directly at * [[Mining#Surface_excavation|Sculpting rock layer with a compass posision (N, NE, E, SE, S, SW, W, NW); this is a well known technique of getting a tile completley flat.pickaxe]]<br><br>If you are having trouble flatening a tile then flatten 1 tile using the "flatten" option, then dig down or drop dirt on tiles to match the outline of that tile.<br><br>Flatening Guide by: --* [[User:Listylister|ListylisterSlope]] 16:09, 13 June 2006 (CDT)an explanation on how to read slopes
Extra tip![[Category:Skills]]Actually you can use the flattening action, if the corners that need to be corrected are ''above'' flat level and it takes no more than 14 seconds.[[Category:While_moving]]If only one corner is 2 steps from being flat, you can use the flattening action here too (19 seconds). --[[UserCategory:Helge|HelgeBabel/D]] 16:43, 13 June 2006 (CDT)

Navigation menu