85
edits
Changes
Jump to navigation
Jump to search
'''Mining is the skill of excavating [[stone shards]], [[marble shards]], [[slate shards]], [[sandstone shards]] and [[ore]] veins.'''
== Opening a mine (Tunnel) ==
Activate [[pickaxe]] '''right click''' any [[cliff]] or [[rock tile]] and select '''mining''' > '''tunnel'''. '''[[Mining warnings|Find potential error messages here.]]'''
*The first step is to make a '''mine entrance''' on the surface which may be done on any [[cliff]] or [[rock tile]].
*The minimum slope of the rock surface to be mined is +1 but also have further requirements. The two lowest corners of your tile will form the bottom edge of your opening. If there are not two corners lower than the others (not equal) you cant tunnel. After opening that lower border will be reshaped completely flat at level of the lower corner.
*If there are two lower corners identified then the opposite border will be the top of your mine opening and will be completely flat as well, leveled at lower corner of the opposite border.
*'''You cannot [[Mining#Surface_mining|surface mine]] to correct an oddly shaped entrance once it is open.''' So you must make sure to have the tile in the exact shape you want it to be before you open the mine.
*When tuneling, entrance tile is limited by reinforced cave floor as any others (requires that all four corner of the entrance tile not be also one of a reinforced tile). So, when you are tunneling an entrance from the outside and receive the message, {{event|inline|The ground sounds strangely hollow and brittle. You have to abandon the mining operation.}}, you most likely have a reinforced floor inside the tunnel you are trying to open. Enter the mine from another angle and remove the reinforced floor.
Mining a cave wall inside of a mine will remove that tile of rock. It takes 45 mining actions to produce the message {{event|inline|The wall will break soon}} after which it takes 1 to 11 actions to fully remove the tile.
* It is possible to mine up, down or flat but only the final action is taken into account. The resulting slope of up or down will be approximately 20. Ceiling will be 30 above the created floor whatever its shape is.
* There are slight deviations in mine slopes (up to 3 "Slope") when a mine shaft progresses.This is based off Mining Skill.
** skill less than 50, +-3
** skill = 70, variance is +-1
** skill = 90+ no variance
* When mining a tile next to an opened tile, slope of the existing tile will be kept but may also change with same variance.
* When connecting two mine shafts, the direction of the mining is irrelevant; one floor will connect to the other floor and ceilings will likewise connect.
* Each action will produce one stone shard.
